Thursday, July 22nd, 2010 at 10:48 am
Question by larryt t: How to remove construction smell (dust from cutting ceramic tile and laminate in door)from newly remodel home ?
My remodeling contractor cut ceramic tile and laminate floor panel in door cause very bad sawdust smell after contraction, it could be from paint, I am not sure. I tried Kenmore air clean machine and fan to blow air out for two weeks, also wipe wall and ceiling twice, i used vinegar, I bought four plants to absorb smell,…etc… please help.
Best answer:
Answer by caballero
Time. But in addition get a couple of very good quality diffusers ,same scent, and put on opposite sides of the room.
Good luck. I have had an oreck air purifier for a couple of years and it works really well.
Add your own answer in the comments!
Thursday, July 8th, 2010 at 4:49 am
Question by mandynjoseph: How do I remove laminate flooring?
It’s those sticky laminate tiles, underneath it is the houses concrete foundation…they’ve been there since the early 80’s I’m guessing. When I try to scrape it they tear apart. Is there a tool to make it easier? I saw them taking it off with a long handeled scraper on T.V., what is that called? It’s a small area so I don’t want to rent one of those stripping machines. Any ideas to make this easier?
Best answer:
Answer by Amber K
Here is a website with directions:
http://www.ehow.com/how_2002639_repair-laminate-floor.html
Add your own answer in the comments!
Friday, July 2nd, 2010 at 4:49 am
Question by yegum: how do you remove wrinkles from thin sheet of metal?
i have a very thin sheet of aluminium with lots of wrinkles i was wondering how you would get rid of wrinkles, i have tried putting the sheet through a laminating machine to see whether it would get rid of the wrinkles however this failed
i have got some machinery but not a lot but any suggestions are welcome
the sheet of metal is not very expensive and is very thin probably less 0.1mm, its lying around so i want to put it too good use
Any help would be appreciated thanks
Best answer:
Answer by Gary D
Unless you have a metal rolling machine,which is not likely unless you have a sheet metal shop, then you are not going to remove the wrinkles. Try to find a use for wrinkley aluminum
Give your answer to this question below!
